ASK74F High Speed (upto 1800mm/min)

ASK74F High Speed (upto 1800mm/min)

Typical End Chemistry of Weld Metal

C%

Mn%

Si%

S%

P%

0.06

1.50

0.35

0.025 max

0.030 max

Mechanical Properties of Our Weld Metal

UTS(Mpa)

YS(Mpa)

ELONG%

CVN -40°C

550 min

460 min

25 min

40J min

[Values obtained with good operating conditions]

Our Nouvarc flux & filler wire in combination can do with two run technique has been proved above properties in buttjoint as well as filletjoint in heavy structural upto 16 mm throat thickness successfully in mass steel construction industries.

Characteristics

Our flux are agglomerated basic type flux for welding ship building structurals, high pressure vessels, ducts & pipes including fine grain steels hence use of our EM12 K wire is recommended by us due to good slag detachability low consumption of flux and smooth weld beed finish with smooth blending as well as appropriate consumption rate and low hydrogen content. Our flux are required to be redried atleast for one hour at 300°C.

Applications

Pen stock shells, pressure vessels. Earth moving equipments, structural, off shore plat forms, blast furnace shells and boilers where UTS upto 540 N/mm2 specified also for machine building, Locomotives, Rail Girders, Crane Girders etc.,

Applicability

  • Current :1000 Amps Max
  • Voltage : 27 - 32 V
  • Polarity :AC/DC +

Packing Particulars

Our packing norms : 25 Kg Flux /Bag (Atm shield) 100 Kg Drum

Enquiry

captcha image
Untitled Document